I ordered four of these for our small non-profit office. Overall, I'm pleased with my purchase and we will be keeping these for a long time.Pros:*Very reasonably priced.*The parts are good, heavy, sturdy wood.*All the parts were included and went together the way they were supposed to without difficulty.*Wood parts were clearly labeled, making it easy to confirm you were working with the right pieces.*Instructions were 95% clear, with only a couple of ambiguous places.*Attractiveness and functionality meets my expectations for the price point.Cons:*All the different screws are in one bag and not labeled with the numbers used in the instructions. Assembly was slowed down by need to continually flip to the front page to see a drawing of what that number screw looked like, and then try to visually match the screws in front of me to the line drawing.*Requires own tools to assemble. Usually these pre-fab deals only need an Allen wrench/hex key which is included with the package; this item requires both a flathead and a Robertson or Phillips head screwdriver at minimum.*Requires power drill to assemble most effectively.On the need for power tools: Each drawer has two roller tracks on it, each held in place by three teeny-tiny screws (18 tiny screws total). The holes for these screws are not pre-drilled. The wood is soft enough that even as a small female without much upper body strength, I could easily enough bear down with a manual Phillips head to drive them in, but it's much more difficult and time-consuming than if I'd had a power drill. A power drill with a magnetic bit would have stopped the screws from slipping and reduced the time per screw from something like 30 seconds per screw (x 18 = 10 minutes just to attach the rollers) to probably 3 seconds per screw (could have attached all the rollers in under 2 minutes). Each drawer has a plastic handle with pre-drilled holes. As with most pre-drilled holes, they're much smaller than the girth of the screw, to create a snug fit. Unfortunately, I lacked the strength needed to drive the screws through the hard plastic with a manual screwdriver. I was able to drive them in just enough to affix the handle loosely to the drawer. It will require a power drill to tighten so handle is flush with drawer face. The screws technically require a Robertson head screwdriver (not common outside of Canada), and I was making do with a Phillips head. Perhaps if I had the Robertson screwdriver I would have been able to get enough torque to drive through the plastic without a power tool.Also good to know: A slight negative which didn't affect my rating: it takes a long time to build. I build a lot of these budget furniture pieces and often somewhat enjoy the process and can whip together most tables and chairs in 20 minutes or less, but it took me about an hour to build the first of these cabinets, without power tools. Halfway through I was getting frustrated and impatient that it was taking so long to construct. I think I'll be able to shave build time down to 30-40 minutes for the remaining three cabinets, now that I've already done it once, and will be using a power drill for the remaining ones. I didn't take off any stars for this, because I don't think there's any way the manufacturer could have made this any faster to assemble, except perhaps pre-drilling the holes for the roller tracks. There's just a lot of pieces involved in a multi-drawer filing cabinet (5 walls of the main body and 5 walls x 3 drawers = 20 total pieces of wood, plus 12 roller tracks). But just be aware that if you don't want to spend 30-90 minutes building one of these, and you're not on a non-profit budget, you may want to consider spending more for a pre-assembled one.